A Self-Powered Microgrid Apartment Complex Is Going Up In San Francisco


posted
Categories: Homes / Dwellings

One of the main requirements of the Passive House model is the building’s exterior envelope must maintain a thermally tight construction, preventing infiltration of outside air and loss of conditioned air. Riyad Ghannam of RG Architecture, the project architect, said one of the many challenges of building a passive house building was finding creative ways to minimize penetrations through the exterior walls in order to minimize thermal bridging. The front façade has an elegant cable-suspended, exposed tube steel balcony system to provide outdoor space at each unit in addition to help shade the west facing windows and minimize heat gain into the space. The balcony structural connections to the exterior wall were carefully designed to minimize penetrations through the envelope.

The 100% electric-only building is designed to be fossil fuel free. The building includes a large roof deck and garden covered by a semi-translucent BIPV, bi-facial PV panel trellis system. The bi-facial design gains added energy production through reflectance back to the panel from the roof in addition to the southern sky facing panels. The trellis system is also planned to serve as a rain catchment system and a very innovative ambient lighting system. Although in the passive house model, photovoltaics cannot be included in source energy offset calculations, the building as designed does meet the maximum total source energy without them.

Inside the building, the energy recovery ventilation (ERV) provides continuous filtered fresh air and improved climate control and air quality for the residents while using less heating and cooling energy use. Passive House buildings use approximately 80% less energy for heating and cooling loads compared to buildings complying with current code requirements. Other energy saving features include a heat pump electric water heater and heat pump clothes dryer in each unit. The heat pump water heater will be located in a closet behind the refrigerator with a high and low vent between them. In this way, a convective heat/cold loop is created. The water heater will use the heat expelled from the refrigerator to heat the water and the cold air produced by the water heater used for refrigeration.


There will also be “new to the USA” non-vented heat pump electric dryers specified for each unit. All the rest of each unit’s appliances will be top of the line Bosch “Benchmark”, ultra low energy models.

Stay tuned for the building’s completion next year and see how well the passive house model performs in a 4 unit building. The Developers, Sol-Lux Alpha LLC and Off the Grid Design, and their Passive House Consultant, Graham Irwin of Essential Habitat, are showing how the common floor and wall areas between units help a building achieve the “highest bar efficiency” of Passive House Certification, and Net Positive Energy, in an very cost effective manner.

+ Sol-Lux Alpha (aka 685 Florida Street)+ RG Architecture / + Off The Grid Design / + Passive House Institute US

via Inhabitat

  Page Turn  


Related articles in Homes / Dwellings